Wednesday 28 September 2016

Make Christmas Special using Metallic FX Day 2


Here's my creation for this week:






This is what you will need:-
Dreamweaver Stencil LL3046 Tall poinsettia
Silver Embossing Paste
White card
Burgundy card
Patterned paper
Dreamweaver Metallic FX powders :- Forestry, Rose Berry, Plum Royale, Amber Gold, Kiwi.
Stencil brush
Palette knife
Low Tack Tape
Silver Mirri board
Heat Gun
Cleaning products for stencil

And this is how I created the card:

1 Take the Stencil and attached to a piece of white card on all 4 sides apply the silver paste, and remove stencil place in water for cleaning.  Take the Dreamweaver Metallic FX powders and using a stencil brush tap the powders over the paste design in the areas you want coloured.

2 Using a heat gun start to heat the design. I always give a quick blast of heat to the back of the card before concentrating on the front.  As the paste is heated it starts to blister and bubble.  If large bubble appear I tend to burst them so the there is no danger of them cracking and flaking off when the design is finished.



3 Cut all the matts and layers and with the layer of patterned paper cut around the design so that the stencilled design will tuck in. Put your card together.

4 You can add to the card by using ribbon around the spine.  I decided that I wanted mine to be clean and simple.

For more inspiration and ideas check out the Woodware blog

Thanks for stopping by.

Gill

No comments:

Post a Comment